Lasernet System Requirements
- 29 Jan 2025
- 1 Minute to read
- Contributors
- Print
- PDF
Lasernet System Requirements
- Updated on 29 Jan 2025
- 1 Minute to read
- Contributors
- Print
- PDF
Article summary
Did you find this summary helpful?
Thank you for your feedback
This page contains details about the recommended hardware and software for machines used to create Lasernet Forms (Developer) and Printing Server (Server).
Hardware
Lasernet Forms Creation Workstation Specification (Developer)
Component | Requirement |
|---|---|
Memory | Minimum: 4GB Recommended: 8GB |
Hard Disk (Free space) | 750MB |
Processor | 64-Bit 2-core processor |
Lasernet Printing Server Specification (Server)
Component | Requirement |
|---|---|
Memory | Minimum: 8GB Recommended: 16GB |
Hard Disk (Free space) | 1.5GB Additional 20GB (minimum) partition for runtime (more may be required depending on redundancy and backup requirements) |
Processor | 64-bit 4-core processor |
Network | 100MBit Ethernet (LAN) |
Software
Supported Operating Systems
See the Lasernet Compatibility Matrix.
Supported Browsers
See the Lasernet Compatibility Matrix.
Lasernet Software Prerequisites
Manually Installed
Microsoft .NET Framework 4.8
Note
If the Lasernet 10 installer notifies you that Microsoft .NET Framework 4.8 is not installed, you must close the installer, manually install Microsoft .NET Framework 4.8, then run the Lasernet 10 installer again.
Automatically Added by the Lasernet 10 Installer
The following components are automatically added to the computer by the Lasernet 10 installer:
Microsoft SQL Server 2017 LocalDB
Microsoft OLE DB Driver 18 for SQL Server
Microsoft Visual C++ 2019 Redistributable x64
Automatically Downloaded and Added by the Lasernet 10 Installer
Microsoft Edge WebView2 Runtime
Note
During Lasernet 10 installation, this component is automatically downloaded and added by the installer. If there is no internet connection, manually download and install the component before you install Lasernet 10.
Note
To install the component, right-click the installer and select Run as Administrator.
Trusted Certificate
Formpipe recommends that you install a trusted certificate on the computer that is running Lasernet Config Server 10.